Well i decided against slow kv for align as the 5020 didnt work out too well on 500 kv range thermaling my jive so i quickly did mx in 500 kv range 7+7 1.32yy, well, not done yet, so much for quickly .....,but only the soldering testing etc so hard work is done. In retrospect 1.25 would have been better fit and cooling. ITs a very nice motor to rewind, only problem is you need more turns in the slot compared to 4035 (6+5 vs 7+7) so mx is actually harder to wind except of course if you do the stronger magnets.
Ralph where to get stronger magnets for them? and what glue do you use for the magnets?