AR7200 wiring

[1275mini]

ok guy what lead goes where ? do i still need the align voltage regulater on the rudder servo ?
the heli is a 600e pro running stock servos a few pictures would be a very big help

[Fabien]

Originally Posted by 1275mini

ok guy what lead goes where ? do i still need the align voltage regulater on the rudder servo ?
the heli is a 600e pro running stock servos a few pictures would be a very big help

Hi Barry,

if this is on the 6000e witht he GVR 7020, as all are stock servos, you don't need to use a step down regulator on the tail, all servos should be powered at 6.0V normaly ( can you give me the model number of your servos so i can double check) ?

If same voltage applies for all servos ( swash + tail) , just wire the tail servo as the others using a receiver / servo port on the GVR 7020 and select the right voltage which will be common to all servos, the AR7200Bx will then be powered by the " receiver" ports at 5.2V and servos at the selected voltage

Best regards,

Fabien

[1275mini]

Morning
servos are DS610 on the head and DS650 on the tail !