Diamond Rotor head..

[nuttzzy]

dose anyone have a 500 600 or 700 Diamond Rotor head?

3,4, or 5 blade?

let me know in here or PM me if you do i have some questions about them please.. thanks..

[jackheli]

Hi,

I have a 600 five bladed Diamond Head. You can see it here:
http://www.helifreak.com/showthread.php?t=467198

What would you like to know?

[nuttzzy]

Hey Jack.. I have some of the grips on order but they arnt gonna be in for awhile cause holidays then weekend and such. Im working on a project, I basically need to know the Dia. of Just the hub and/or the length from the grip tip to the feathering shaft shoulder that screws into the hub. Its 114MM from center of hub to tip of the grip. But, I need to know another measurement for my project.. If I have one of the other two measurements I can figure the 3rd. Would be very much appreciated if you could help me out. Thanks.

[jackheli]

Is this what you are looking for? Not sure I can measure it precisely...

[nuttzzy]

Yes sir. That dimension. I gotta custom make a swash also. Don't have to be exact just as close as you can 1/16 of an inch or so. On the site it's measured in MM nearest MM would be fine to lol. Just whatever you can get


Beep, Beep, Honk, Honk, Over and Out Rotorhead

[jackheli]

81.6mm

Good luck on your project.

[nuttzzy]

Thanks man.


Beep, Beep, Honk, Honk, Over and Out Rotorhead

[jackheli]

This measurement?

[nuttzzy]

Originally Posted by jackheli

This measurement?

yes sir..