my back plate sensor bracket

Jesse · 12-13-2012, 03:31 PM

Just wanted to share what I did to install my back plate sensor. I dont know what sensor this is i bought it used with my multigov, but it a bracket that had 50 90 printed on it and you moved the sensor by pulling one screw out.

bobbyra · 12-13-2012, 10:34 PM

You maybe have to grind down two of the ribs to get it closer to the back plate.

Jesse · 12-14-2012, 05:52 AM

No grinding fits perfectly flat against the back of the plate. Once you take the other bracket off its small enough to fit in there

bobbyra · 12-14-2012, 11:22 AM

Less work is better good for you.

12-13-2012, 03:31 PM	#1
Jesse Registered Users Join Date: Jul 2004 Location: houston, tx.	my back plate sensor bracket Just wanted to share what I did to install my back plate sensor. I dont know what sensor this is i bought it used with my multigov, but it a bracket that had 50 90 printed on it and you moved the sensor by pulling one screw out. Attached Thumbnails

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-13-2012, 10:34 PM	#2
bobbyra Registered Users Join Date: May 2008 Location: ft myers fla	You maybe have to grind down two of the ribs to get it closer to the back plate.

12-14-2012, 05:52 AM	#3
Jesse Registered Users Thread Starter Join Date: Jul 2004 Location: houston, tx.	No grinding fits perfectly flat against the back of the plate. Once you take the other bracket off its small enough to fit in there

12-14-2012, 11:22 AM	#4
bobbyra Registered Users Join Date: May 2008 Location: ft myers fla	Less work is better good for you.