X-cell 30???

dmc45 · 12-16-2012, 07:43 PM

Received what I believe is an Xcell 30. I'd like ot get it running but have a lot to learn about this heli. Everything looks good but the throttle does not move. Maybe froze up but it does not look like it moves. It has a servo tied to it so it must move right? I have experience but all electric...like the blade SR. Also, how do I match up RX and TX? Should I purchase a new set.

Any information on this heli would be greatly appreciated.

THanks,
Doug

Rudy · 12-16-2012, 11:15 PM

disconnect the throttle linkage from the carb. Will the carb work with the linkage disconnected.

if not you need to remove the engine and then the carb from the engine. Soak the carb in some alcohol that should free it up.

dmc45 · 12-17-2012, 04:13 PM

Thank you! It does not move so i will take it apart and soak it.

flyin dan · 12-18-2012, 04:40 AM

Rons Heli Pros south is your best bet for Min-Air parts. Tear it down and check all bearings, the X-cell 30 is still a good machine when setup properly.

12-16-2012, 07:43 PM	#1
dmc45 Registered Users Join Date: Dec 2012 Location: Tampa, FL	X-cell 30??? Received what I believe is an Xcell 30. I'd like ot get it running but have a lot to learn about this heli. Everything looks good but the throttle does not move. Maybe froze up but it does not look like it moves. It has a servo tied to it so it must move right? I have experience but all electric...like the blade SR. Also, how do I match up RX and TX? Should I purchase a new set. Any information on this heli would be greatly appreciated. THanks, Doug

12-16-2012, 11:15 PM	#2
Rudy Registered Users Join Date: Jun 2005 Location: Homeless	disconnect the throttle linkage from the carb. Will the carb work with the linkage disconnected. if not you need to remove the engine and then the carb from the engine. Soak the carb in some alcohol that should free it up. __________________ Rudy - Bend OR/Houston TX We had a great country once. You know what made it great? “I can.” Then the weak came along, “the I cant’s” and destroyed it.

12-17-2012, 04:13 PM	#3
dmc45 Registered Users Thread Starter Join Date: Dec 2012 Location: Tampa, FL	Thanks Thank you! It does not move so i will take it apart and soak it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-18-2012, 04:40 AM	#4
flyin dan Registered Users Join Date: Jul 2011 Location: Beloit WI.	Rons Heli Pros south is your best bet for Min-Air parts. Tear it down and check all bearings, the X-cell 30 is still a good machine when setup properly.