Trex 450 SE V2 Overview VIDEO

[Finless]

Originally Posted by checkflag

The links on your original post are dead.

Which links? I just checked my links in post #1 and they are working for me.

Bob

[pizmo]

Hello Bob,

Will you do a review of the new 450pro 3gx super combo?

Regards, Mark

[Finless]

Probably not. Align has not asked me to do anything since the 450 Pro came out. Not sure why but honestly I have no desire to buy the V2 3GX any time soon for myself. I am enjoying my Vbar 450 Pro. However if I ever do buy one, trust I will do a video on it.

Bob

[Kimono12]

he items used in this build are as follows:Align T-Rex 450 SE V2
Align 430XL motor
Align 2100 18C lipo
Spektrum 6100 rx
Futaba 401 gyro
Hitec HS-56 Servos
Futaba 3154 tail servo
I will go through the build a step at a time. I have not followed the manual as the SE V2 comes mostly assembled. I built the model in the most logical manner given what is already assembled.

[bekbaev]

Dear Mr. Bob.

I have grown on your build videos over the years. )))

[chr15tophe]

Just building the trex450 sport, any tips on getting the frames to sit level on a glass table, as per manual page 9, I've loosened all the screws and slowly tightened them all but it always tweaks when I tighten the motor mount? Should I be concerned about a 1-2mm rock on the front right side, im guessing yes?

Thanks in advance

[Finless]

Whats important is that all the bearing blocks line up e.g. the main shaft goes in smoothly into the blocks, etc. On a 450 with a plastic bottom plate it is no big deal if that is not level.

Bob

[chr15tophe]

Thanks bob great advice

[Immi]

Thank you Bob

i was rebuilding this week my T-Rex 450 SE V2 after a 3 year break and all i neede was to watch your Videos again,you did a great job back then :-)

[Ibrahim Muneer]

Originally Posted by Finless

OK here is a complete overview about the Trex450 "official" V2 heli. I show all the changes good and bad.
This does not show a build video as I think that would be redundant (it's not that different) but does go into all the changes and I do a good overview and build of the major change which is the head and thrust bearings.

If you all feel I need to cover some build things let me know and I will.

ENJOY!

VIDEO -> Align SE Version 2 overview PART 1 (50 Megs)

VIDEO -> Align SE Version 2 overview PART 2 (50 Megs)

Here is the V2 Manual in PDF High Resolution 20 megs
VIDEO -> Align SE Version 2 PDF Manual High Rez (20 Megs)


Bob

Hi Bob, I need your help setting up my HK 450 v2 heli from hobbyking, i need help only with ccpm settings and head assembly correctly. I am having alot of difficulties to set my heli up, because im new to this hobby, i have flown my heli with bad settings but it is so much difficult to fly it with bad settings. Kindly make a build video for trex 450 se v2 with hk t6a Radio plz. or build exactly hk 450 v2 if you can please. so that i will be able to set head rotor assembly perfectly. i have seen your build video of trex 450 se, its great , but it is not helping me with ccpm and head assembly and linkages, may be there are some differences between my heli and the trex 450 se, but not se v2 .
Regards
Ibrahim