START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Flybarless Helicopter Systems CSM Cyclock, Helitronix Multi-mixer, Spartan AP2000i, Firmtronix Digimix-3, Gyrobot, SK360and AC3X |
|
LinkBack | Thread Tools | Display Modes |
12-19-2012, 04:27 PM | #1 (permalink) |
Registered Users
Join Date: Mar 2011
|
Problem programming a NEW AR7200BX
Hi guys,
I’m setting up a FBL Rex500. I have set my DX8 to all the settings recommended for the Blade 500X. I did keep a linier pitch setting as recommended in the AR7200 manual. During setup when I get to step E (rudder servo end points) the servo won’t move. All servos move correctly when the 7200 is not in setup mode. I was getting ready to send the 7200 back to Horizon and in the mean time I purchased another AR7200BX. SAME PROBLEM!!!! Step E rudder servo won’t move. I have watched the videos here for setting up the 7200 and in step E the servo is supposed to move to set the end points. What the heck am I doing wrong? 2ea Ar7200, 1ea DX8, same issue. Any ideas? BTW I called Horizon Hobbies to discuss this problem and they were no help
__________________
That's gona leave a Black & Blue,,, on my wallet! Trex 500 FBL X 3, Phantom 3 standard, DX8. |
Sponsored Links | |||
Advertisement |
|
12-20-2012, 02:36 AM | #2 (permalink) |
Registered Users
Join Date: Feb 2007
Location: England
|
What do you have for your Tail gain in the Tx - I have heard of people having similar problems if the Gain was set to zero (or very low).
Good luck |
12-20-2012, 05:59 AM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Mar 2011
|
Hi Mike
if your talking about the gyro in the DX 8, the normal position is 34.5
Everything else is set according to the Blade 500X manual Page 7 Sorry, I can't seem to be able to attach the manual.
__________________
That's gona leave a Black & Blue,,, on my wallet! Trex 500 FBL X 3, Phantom 3 standard, DX8. |
Thread Tools | |
Display Modes | |
|
|