Curves with Naza H

[boowho]

OK, I do not fly any 3D; in fact my radio does not even have an idle up switch configured.

I have a Trex 450 cone with ONLY these two curves configured on the radio and shown below:

THR -100 -20 30 70 90
PIT -30 -15 0 50 100

Will these be OK in all three Naza modes?. I don't want the damn thing to jump up or down several feet when I switch from Normal to ATTI or ATTI/GPS. I know that the Naza locks in the RPM and maybe the pitch setting when leaving Normal mode.

Boowho??

[fredouille]

HI

I spent my week end on my trex600 to migrate from 3GX to NAZA H

to setup the naza you must reset the curves to default, then in the naza you will configure some stuffs which changes everything in the possible existing curves that you may have with a 3GX

impossible to answer you if your curves are ok, throttle should be the same, Pit, you have to mesure the pit and each point and setup accoring to your trex documentation

[boowho]

Originally Posted by fredouille

HI

I spent my week end on my trex600 to migrate from 3GX to NAZA H

to setup the naza you must reset the curves to default, then in the naza you will configure some stuffs which changes everything in the possible existing curves that you may have with a 3GX

impossible to answer you if your curves are ok, throttle should be the same, Pit, you have to mesure the pit and each point and setup accoring to your trex documentation

Thanks for the advice.

Boowho??

[fredouille]

I will tell you today if it works...

I hope I will not crash.. the Atti mode looks strange the cyclic don't stay horizontal after switching on atti or gsp mode

[x50B]

On the bench that is normal to see.

[fredouille]

?? what do you mean?

[boowho]

I found another thread where it was stated that DJI's curve recommendations for the Naza H are as shown in the attached pics.

Boowho??

[fredouille]

as I told you.. the pit curve depends on your physical setup.. you need to setup the number of degres which are in the documentation of your heli, nothing else.

[boowho]

Originally Posted by fredouille

as I told you.. the pit curve depends on your physical setup.. you need to setup the number of degres which are in the documentation of your heli, nothing else.

OK, I will try that and see what happens.

Boowho??

[boowho]

Originally Posted by fredouille

as I told you.. the pit curve depends on your physical setup.. you need to setup the number of degres which are in the documentation of your heli, nothing else.

OK, never done it that way before, but it worked out really well.

Checked ALIGN 550E manual it called for 0 to -2 at low stick, 5 at center stick and 10 at full stick. Locked my flybar perfectly level, put digital pitch gauge on blade and adjusted the pitch curve (at low mid and hi) in the TX while watching the pitch gauge.

I've learned something..... Thanks

Boowho??