Advanced tail menu

[GJacksonF3N]

I searched 3 very where in the ikon software and do not see the advanced settings for tail. I would like to increase the piro rate and decrease the tail stop.

[kev0712]

In the advanced menu....click the option that should say"common"bank, and then you have to click to bank 1,2 or 3...then it will allow you to change the tail settings for that bank

How it helps

Kevin

[GJacksonF3N]

Thanks! Unfortunately I did not see bank anywhere or common bank.

[MSH-Direct]

Top left side of screen under the drop down menus

[GJacksonF3N]

Once I enter the advanced menu I don't see a drop down menu. I will check again when I get home. All I did see were Receiver, CCPM, etc. Then setup 1, 2, 3.

[keyscrt]

Click on setup 1, 2 or 3 then on tail then ajust tail rotational speed

[GJacksonF3N]

Found it, thanks! I will test the new settings in the morning. Is there a way to decrease the tail stop gain? It is so strong it creates some bounce back. I just now checked the boxes for the precomps, hope that helps with something.

[Chep]

Reduce D gain until you find the sweet spot.

[GJacksonF3N]

If the rain stops i will see how that works. I also turned off the precomps until I get the tail perfect. Had to change from 12 pwz (?) To 8 (in the castle software, sorry I got the letters wrong, about to eat) that reduced the vibes surprisingly. Now just need the stops worked on in the D gain menu. Learning a ton about ikon!

[GJacksonF3N]

Lowering D worked. Had a good test flight until the rain came. Now I wish my "v" flew as well. Could there be a switch in my future?!