SK360 on RJX Xtreme 50

[alvinchai]

Initial testing of the SK360 on a RJX Xtreme 50, using the default 3D files in the program.

I will play around with the program settings a bit more once I get more flights in, but so far the default 3D files works pretty good. Approx 13 degree pitch, 10 degree cyclic.

SK360 Flybarless X-treme 50 RJX heli Test by Alvin Chai (5 min 40 sec)

Alvin

[Max2342]

Could you make msome pics of your setup and mounting positions on the heli. Especially i am interested in the impact of vibrations on the sk360. I ordered one for my knight 3d so some pics would be great.

max

[alvinchai]

Some pics below, sorry for the delay.

I'm using the spartan gyro tape for mounting, no vibration issues so far.

[Skookum]

Hi All,

I've been looking at doing a firmware update to make the 4th servo channel optionally an extra input, which would switch between two "advanced" tab gain-profiles. So, how useful would this be?

There are a couple of limitations. If it were to be used as a remote hiller-gain as well, it would only read a new value when mode switch is toggled. The hardware just isn't suited to allow full-time precision readings for that pin.

The other is that the "no computer" setup feature might have to be dropped to make room. Does anyone use that feature?