Register Now

dlregis · 03-04-2013, 03:44 PM

Due to an unfortunate series of events (all my doing), one of the pins on the tail-motor connector broke off in the socket on the 3-n-1 board. I've tried just about everything to extricate it, but there's just not enough to grip. The board is otherwise good, so if I can replace just the socket then I've saved myself some money.

Does anyone have the specs for those connectors (pitch, pin size)? I'm pretty sure I can source them ... might have to buy more than I need, but that's OK.

Thanks in advance!

SYMAWD · 03-04-2013, 03:49 PM

http://www.topcopter.com/mCP-X-FEMAL...ECTOR-p/92.htm

dlregis · 03-04-2013, 04:41 PM

Thanks again... order placed!

03-04-2013, 03:44 PM	#1 (permalink)
dlregis Registered Users Join Date: Mar 2010	Source for 3-in-1 motor connectors... Due to an unfortunate series of events (all my doing), one of the pins on the tail-motor connector broke off in the socket on the 3-n-1 board. I've tried just about everything to extricate it, but there's just not enough to grip. The board is otherwise good, so if I can replace just the socket then I've saved myself some money. Does anyone have the specs for those connectors (pitch, pin size)? I'm pretty sure I can source them ... might have to buy more than I need, but that's OK. Thanks in advance!

03-04-2013, 03:49 PM	#2 (permalink)
SYMAWD Registered Users Join Date: Mar 2010	http://www.topcopter.com/mCP-X-FEMAL...ECTOR-p/92.htm __________________ Blade 130X Blade mCP X (Bl) Blade Nano CP X Prôtos 700 Xtreme-Production

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-04-2013, 04:41 PM	#3 (permalink)
dlregis Registered Users Thread Starter Join Date: Mar 2010	Thanks again... order placed!

Register Now

Log-in