What servo do you have?

[doubletap]

Does anyone upgraded their servos on their 500l dominator? Does bk servos fits? Thanks

[DWayte62]

Not familiar with the frame width of the dominator but I switched from Align DS510M servos to BK 5001HV servos for cyclic and a 5005HV for the tail on a 500 Pro DFC and had to purchase Align part #H50057T so I could use the shims in the set to move the BK servos out so there was clearance between the front two. I also had to do a bit of frame modification with a dremel tool to get the BK servos to fit since they use a standard size motor that bulges out the sides of the servo case. I also had to remove the tops of the servos to mount them as there is no clearance for the servo lead. I think the BK servos are a bit overkill for my particular model as I have not seen any significant increase in real world flight performance over the DS510M servos though I am still playing with the set up.

[Scjon03]

MKS 9767 servos. Didn't need anything to make them work.

[gixerfien]

This is how I did mine, make sure you look at the end of the posts for my corrections/mistakes made in the OP write-up.

https://www.helifreak.com/showthread.php?t=704831

[dchekas]

Align will be releasing new Mini/Micro HV servos.

The specs are pretty impressive:

[gixerfien]

Originally Posted by dchekas

Align will be releasing new Mini/Micro HV servos.

The specs are pretty impressive:

While that is pretty cool, I would still never like to use align servo from my experience, better servos are always better

[Van Scott]

Just be careful if using BK on your Cyclic as they are too long for the 500Pro DFC. The Torq CL5180hv are excellent servos and the BK DS5005 works well on the tail. I'm blown away with performance over stock align which gave up at just over 500 flights.
See the difference in case depth in the top photo. You may just get away using BK all around with the L as the frame is a little wider than the Pro. I had to go with the smaller Torq minis and have zero regrets.