1 blink error code - jive won't arm.

[daza20]

Hi guys, I have tried to arm my jive 100lv with a 600mx and a 4025-1100. Every time I connect my flight pack I get the 1 blink error code! I have 0-100% throttle curve with end points at -100 to 100. I even tried lowering the end points with no luck. All being done with a dx8.

Thanks

[Stolla]

that's connection defective, if your connections are ok move the wires away from the esc, I.e. don't double back against the side of esc

[daza20]

Yeah I tried that. I have the esc off the heli. I just don't know what to do any more.

Anyone?

Thanks.

[Stolla]

have you tried different receiver

[daza20]

Yes, have tried vbar with 2 spectrum sats, ar8000 and ar7010. I have also hooked up a servo to the throttle channel and all the servos move.

[Stolla]

ok please provide more details, plug master into rxb , bind to vbar spektrum digital centre, check for thr movement in software, calibrate jive to tx, you don't have to do endpoint calibration as per mr mels videos, just do the way the manual states for now. Reverse thr channel on tx if it doesn't arm. If still doesn't work enter jive settings and reset mode 1 then activate mode 4
Then post result of all this here, it may be as simple as a setup problem our internally damaged wire, is this new or old jive. Please provide as much detail possible but start with one setup till we get it working,i.e. Vbar with sats

[dl7uae]

1 blink at poweron:

If your motor is not defective and there is no short of one of the motor lines to any potential (chassis or whatever)...

I am not allowed to interpret it in plain text, but: The Jive is probably defective.

Tom