What's the best Bec?

[Excalibur3]

I would like to run a hercules HV bec but I noticed there is a bunch of diff kinds. I'm building a 700L top super combo. I want to run 8v
If someone could give me a link I'd appreciate it thanks.

Trex700ProDFCHV,Goblin 770,Goblin 570, 14SGH

[nightflyr]

I believe this is what your looking for...

http://www.western-robotics.com/herc...BECPRO_hp.html

[el_verde]

Yeah buddy!!!

I have this BEC, The Hércules súper bec pro, on my trex 700L top... Configurated on 8.2V, directly of 12S batteries...without lipo 2S, Works awesome

[Larry227]

I'm running the Super BEC but not the Pro version. Not even sure they had the Pro back when I bought mine which was close to three years ago.

http://www.western-robotics.com/herc...er-BEC_hp.html
I run it off 12s and at 6v although it will also do 8.4 and 9v

[Excalibur3]

Thanks guys exactly what I was looking for

[Rdavis007]

Originally Posted by el_verde

Yeah buddy!!!

I have this BEC, The Hércules súper bec pro, on my trex 700L top... Configurated on 8.2V, directly of 12S batteries...without lipo 2S, Works awesome

Are you plugging your servos directly into your BEC or into the FBL? I too am looking to install this BEC with HV KBS servos. I would will be installing it on an S-Bus configuration.

[Excalibur3]

Originally Posted by Rdavis007

Are you plugging your servos directly into your BEC or into the FBL? I too am looking to install this BEC with HV KBS servos. I would will be installing it on an S-Bus configuration.

I too run vbar with and sbus r7008sb so I'm not sure yet. I think I have to have the servos plugged into the vbar.

[K2Freak]

Servos into vbar, I put both battery leads into it too. Then I run 1 sbus wire, and a second lead from vbar to Rx with the white wire removed. The second one is probably not necessary due to low rx current draw, but there are just the right number of ports...

[Rdavis007]

Originally Posted by Excalibur3

I too run vbar with and sbus r7008sb so I'm not sure yet. I think I have to have the servos plugged into the vbar.

I will be running a Spirit FBl. I had just read the Hercules BEC recommended plugging the servo leads into the BEC for HV servos. I was not sure how reliable this configuration works as I have not seen anyone using it. I will also be using the 7008SB Reciever across s-bus.

Thanks