Trex 700 with a HC3sX

[ranchhand]

I was wondering what anyone with a HC3sX mounted on the gyro mount is doing about the canopy hiting the wires. It would of been great if they just had the wires coming out of the side of the controller ( like the Ikon ) but they come out the top and I don't think there're going to change that configuration. It would be great if someone made a 90* servo fitting, but I've never seen one of those yet.

[ArchmageAU]

Originally Posted by ranchhand

I was wondering what anyone with a HC3sX mounted on the gyro mount is doing about the canopy hiting the wires. It would of been great if they just had the wires coming out of the side of the controller ( like the Ikon ) but they come out the top and I don't think there're going to change that configuration. It would be great if someone made a 90* servo fitting, but I've never seen one of those yet.

3SX on 700E. mounted on front plate. Canopy does touch wires (but not crushing in any way). Never had an issue with this setup though.

You could mount the 3SX sideways if you want.

[ranchhand]

I was actually able to get the wires low enough so their not touching the canopy. With the stock canopy there was more room and it was never a problem, but I had a Canomod canopy painted for it and the canopy flattens out in the area of the gyro mount which was making it a little to tight for me, the heat shrink on the wires was getting worn.
Anyway, all fixed.

[mzbaby123]

Hi guys,
I'm just setting up my new Dominator - as I'm flying a HC3sx also in my 550e, I will use the same system in the Dominator. Are you willing to post your HC3sx settings ? I would like to compare them to my 550 settings ?!.

regards
Martin

[ranchhand]

Have you looked here?
https://www.helifreak.com/showthread.php?t=643043