START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Gryphon Electronics Gryphon Electronics Factory Support Forum |
|
LinkBack | Thread Tools | Display Modes |
04-01-2013, 04:33 AM | #1 (permalink) |
Registered Users
|
Voltage Drop @8.4V - how much? (7025LMT)
Hi Folks,
I installed this nice 7025LMT in my new 800 Suzi Laos. Setup is 12s ->BEC ->8.4V, RJX HV Servos (0.05ms, 21kg) - known as moderate amp drawing. I played a little bit on the work bench and noticed voltages from 8.5V to 7.4V in my V-Bar. There was no Stress on the Servos or bent Rods! Is the Voltage drop in a normal Range? Is it better to switch to the 7.4V Setting? Thanks for your advises
__________________
Velos 880, 800e Pro DFC, Mostro 700, Suzi Laos 800 RJX Xtreme 90EP, Outrage F50, Goblin 570KSE, Goblin 380 |
Sponsored Links | |||
Advertisement |
|
04-01-2013, 04:46 AM | #2 (permalink) |
Registered Users
Join Date: Apr 2008
|
Voltage Drop @8.4V - how much? (7025LMT)
I would set to 7.4v, i do this with kosmik and hv servo. Those servos are high amp draw setting to 8.4v makes it worse! Set to 7.4
|
04-01-2013, 12:13 PM | #3 (permalink) |
Registered Users
Thread Starter
|
Thanks for the advise.
I'll try 7.4v and report.
__________________
Velos 880, 800e Pro DFC, Mostro 700, Suzi Laos 800 RJX Xtreme 90EP, Outrage F50, Goblin 570KSE, Goblin 380 |
04-08-2013, 11:18 PM | #4 (permalink) |
Registered Users
|
Are you guys running 12s right into the Gryphon or just wiring it to one 6s pack?
|
04-09-2013, 04:56 AM | #5 (permalink) |
Registered Users
Join Date: Apr 2008
|
Im running straight 16S on mine
|
Thread Tools | |
Display Modes | |
|
|