servo problem I think

[4503D]

I have just rebuilt my nano cpx as I crashed and broke the arm bit which holds the canopy on. Everything was working fine before taking apart bare in mind. Now assembled and I am at a lost as to know what has happened or what I should do. Ther servo on the right does not moveas it used to and when I spin up tje heli does not want to lift off and just topples itself over as if all the controls have changed. Any ideas on what I can do?

[NCcraig]

A servo not working or plugged in will not allow the heli to take off. Maybe you tore a leg the servo connector off the 3-n-1 removing the plug. Swap a known good servo for the one that is not working and see if works in that location.

[4503D]

Would that also explan why the controls seem to have changed. Ie left goes right and back goes forward?

[NCcraig]

Probably not but plugging them back in the wrong port may. Although a bad servo has been known to do weird things to the 3-n-1

[HeliKhorazy]

On a off topic note, when the canopy pins break again, which they inevitably will, you could always get a nano pin fixer gizmo. As for your problem at hand craig is better suited To help than i. Your current problem stumps me as well.

[4503D]

Thank everyone for the advice, it was a simple as having the wrong servo wires plugged into the wrong connection on the board. Up and flying again. Many thanks