DX6i settings for ParkZone Radian (PNP or RTF)

[chemicalflava]

After an extensive Google search, I can only find people talking about the Radian Pro and a DX6i. It seems like there's some significantly different features on the Pro versus the non-Pro, so I don't want to use the settings being discussed for the Pro.

I'm definitely tempted to just go with the way the DX6i bound to the TX, but the (first and) last time I did that, it turned out disastrous for my 450 3D.

[hyperfly]

My [Radian] sailplane mix for DX6i radio:

http://www.rcuniverse.com/forum/m_97...tm.htm#9770989

Sure. The dx6i only has 2 mixes, but crow still possible you will just have full up or down movements.

YOUR RX:

-using a y harness with built in servo reverser on flaps
-ar6200 full range
Aux1 -left sailplane aileron
GEAR - put your y harnessed servo reverser here for flaps of your plane
RUD -rudder
ELE -elevator
AILE -right sailplane aileron
THRO -esc
BATT -rx battery or bec

MIX 1

AILE > RUDD ACT
RATE L + 75% R +75%
sw mix trim act

MIX 2

GEAR > AILE ACT
RATE L + 0% R +0%
sw elev d/r trim act

WINGTAILMIX
DUALAILE ACT

FLAPS

NORM < 0 0
LAND ↓66 ↑23

What can you do with this?

normal flight: ail - thro - elev - rudd
flaps down: gear switch
airbrake: both ails rasied (ele DR switch)
crow: ails up and flaps down

REMEMBER FOR CROW YOU HAVE TO HIT GEAR SWITCH AND ELE DR SWITCH TO INITIATE CROW.

THIS IS ALL I COULD FIGURE OUT FOR THE DX6i AND USE IT ON MY SAILPLANE AND WORKS VERY WELL.

Complete thread: http://www.rcuniverse.com/forum/m_97.../anchor/tm.htm

Support articles:

Mode Switch for DX6i:

http://forum.freeflysystems.com/inde...160/#post-3464

Spektrum DX6i & Radian setup instructions:

http://forum.freeflysystems.com/inde...tructions.412/

Radian, Spektrum DX6i and throttle cut - Help:

http://www.rcgroups.com/forums/showt...1232791&page=2

----
hth, hyperfly