 |
START HERE |
|
| Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
|
|
|
Unregistered
|
||||||
| Outrage RC Outrage RC - and XP Li-Po Factory Support Forum |
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
02-18-2012, 04:46 PM
|
#1 (permalink) |
|
Registered Users
Join Date: Nov 2009
|
Help needed
Hello! I'm in the middle of building an Outrage Velocity N2 and I'm a little stumped at how the Stepped Shim washer should be facing on the one way hub assembly. Should the wide shoulder or lip of the washer face down on the hub or up towards the bearing block? I searched the internet and cannot find the answer to my question. Your time and answer would be greatly appreciated!
Thanks Mike |
|
|
| Sponsored Links | |||
|
Advertisement |
|
||
|
02-18-2012, 09:19 PM
|
#2 (permalink) |
|
Registered Users
Join Date: Mar 2010
|
From what I can tell, it needs to go in with the smaller diameter step facing up to the bearing inner race in the middle main shaft bearing block. If you put it in with the larger diameter facing up, it may rub on the bearing shield.
|
|
|
|
|
02-18-2012, 09:48 PM
|
#3 (permalink) |
|
Registered Users
Thread Starter
Join Date: Nov 2009
|
Crap I got it on backwards if that's the case ... I installed it wide part of the Shim washer facing up! Thanks Bryan!
Cheers Mike |
|
|
|
|
02-18-2012, 10:19 PM
|
#4 (permalink) |
|
Registered Users
Join Date: Mar 2010
|
You may want to wait for a few more inputs, or pm someone like dominicd.
|
|
|
|
|
02-18-2012, 10:50 PM
|
#5 (permalink) |
|
Registered Users
Thread Starter
Join Date: Nov 2009
|
Well I took it apart to flip the step washer and heck I think I was right the first time ... Thanks for the replies Bryan I appreciate it ... I think I'll take your advice an PM someone like dominicd on this issue. Thanks again!!
Cheers Mike |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
