controls are frozing after 7 secounds

[heliforlife]

Hello

I havent flied much in the last year.
I found my blade 130x, got a new gear set for it and tried to fly it.
It flies, but after 7 secounds aroud there, everything freezes. I can not do anything. I put the throttle down and after some secounds again it stops and falls from the air into the ground.

I tried powering it on and play with the cyclic servoes without having the motor spinning and they dont freeze while I`m doing that.

So, does anyone have any suggestions for me?

[3D Ambitions]

Only thing I can think of is a bad 3in1 board. Is the 130 loosing signal from your radio when it freezes?

[Stringrazor]

If it's OK with no throttle, then it could be the ESC part of the board or perhaps a bad motor. It sounds like it may be trying to pull too much power from the battery and causing a power "brown out". does the motor get hot very quickly?

Remove the main and tail blades, bind, and power up. See if the motor is getting hot very quickly before the power goes out.If so, it's likely a bad motor.

[JonJet]

If the battery is the same age as the 130X...it may be a bad battery...

Be sure you charge in Balance Mode...regular charge mode will kill it in a hurry