Gpro tail correction backwards on v1.2

[RV_7A]

Please only comment if you have a Gpro and using v1.2. Hoping someone may have some info on the issue of the gyro moving the tail blades the wrong direction using v1.2 software. Seems the only thing that affects this is the “Select Gyro Mount” location. Setting it up the correct way within the iOS interface on the front of my 700 placed upright and servo connections towards the rear is what gives me incorrect movement. The swash gyro works correctly. If I select the gyro upside down and on the rear with servo plugs rearward is the only thing that will give the proper correction. Note: When I move the rudder stick left the blades point to the right but when I move the tail of the heli right the blades point towards the right. I have an email into Jeff Fassbinder but have not heard back from him.

Thanks!

[R/C Speed Nut]

I have v1.2 and have not seen what you are experiencing.
Is the computer software showing correct rudder movement?
Is the tail servo reversed in the tail setup screen?

[RV_7A]

Problem was solved reversing the servo in the radio. But this actually reverses the gyro. Took me a while to figure it out.


Jeff B.

[tourerjim]

Ive had same problem, in the end i reversed switched tail in tx to get the correct tail correction, hoping to fly tomorrow.

[doubletap]

Just a quick one, after reversing the rudder from the TX interface reacts in a reverse way to,
When you give a right rudder on TX it goes to the left in the interface, would this be an issue or not a problem at all since i got the rudder responding in a correct manner anyways...
Thanks for your help guys. Never had this with my 450l with gpro. So i am a bit confused.