START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Jeti Duplex Radio Systems Jeti Duplex Radio Systems Support |
|
LinkBack | Thread Tools | Display Modes |
Sponsored Links | |||
Advertisement |
|
01-09-2014, 08:26 AM | #42 (permalink) |
Registered Users
Join Date: May 2013
|
Not sure but no matter what I did, model type or settings, the left
Roll was somehow effected by dual rates, throttle and flight Mode switch. At some combinations of these switches, there was some left roll, some none and others uncontrollable roll to the right. This is on rf7 btw.
__________________
Bubba Goblin 700 Jeti DS-16 |
01-28-2014, 03:39 PM | #43 (permalink) |
Registered Users
Thread Starter
Join Date: May 2011
|
Finally got time to solder and set this up. The soldering was a snap thanks to the great pictures and HF trail blazers in this forum!
Programming Jeti and RF7 was somewhat of a challenge. For some reason my channel 1 was always acting funky in RF, even though it looked perfect from the Jeti. I worked around this by not using channel 1 and moving aileron (roll) to channel 7. All good now. I played with the PPM frame rate between 10 and 30 ms with no improvement on this flakey channel 1 problem. Settled on 20ms as recommended. Bubbasanjohn, Was that the same problem and fix you came up with?
__________________
Jay - Diligentia, Vis, Celeritas
Lynx / OXY Team Pilot, Zeal Team Pilot |
01-28-2014, 03:48 PM | #44 (permalink) |
Registered Users
Join Date: May 2013
|
yes I did fix it. Its kind of convoluted. let me go get TX and Ill post back the solution.
__________________
Bubba Goblin 700 Jeti DS-16 |
01-28-2014, 04:07 PM | #45 (permalink) |
Registered Users
Join Date: May 2013
|
Ok, here is what works for me.
RX set up I am using a r3-ex. I have output mode to ppm negative, output period of 20ms, channels 8. (selected ppm - as we are setting up a futaba radio) TX. Set up a heli model named realflight. Mechanical swash, standard flight modes and typical throttle curves. servo assignments: 1=roll 2=elevator 3= throttle 4=yaw 5=2 pos switch 6= flap (7 knob on my tx) 7= 2nd 2 position switch 8= 3 pos switch. I did have to add +64% right roll trim to compensate for realflight fubarness. Realflight Set up in RF, Futaba TX, edit to the following RF ch1= 1aileron ch2= 2 elev 3= throttle 4= rudder 5= dual rates 6=flaps 7= REVERSED 7 smoke 8=mode. I have both check boxes below enabled to allow software radio mixes and enable software radio dual rates and expo. Save as another TX name, I used jeti. That should do it.
__________________
Bubba Goblin 700 Jeti DS-16 |
01-29-2014, 04:39 PM | #46 (permalink) |
Registered Users
Join Date: Apr 2011
|
So this my be a dumb question but I need to ask....
My RF 6.5 came with a remote, not small USB box like my phonix did. Where did you guys get the small black dongle for RF ?? Last edited by Spinny02; 01-29-2014 at 07:32 PM.. |
01-29-2014, 07:42 PM | #47 (permalink) |
Registered Users
Join Date: Apr 2013
|
Part of RF7 might be available separate but I doubt it??
|
01-29-2014, 08:18 PM | #48 (permalink) |
Registered Users
Thread Starter
Join Date: May 2011
|
__________________
Jay - Diligentia, Vis, Celeritas
Lynx / OXY Team Pilot, Zeal Team Pilot |
01-29-2014, 09:39 PM | #49 (permalink) |
Registered Users
Join Date: May 2013
|
Yeah dongles are not interchangeable. Rf 7 is better than 6.5 IMHO. Also easier to set up with jeti.
__________________
Bubba Goblin 700 Jeti DS-16 |
02-01-2014, 09:03 PM | #50 (permalink) |
Registered Users
Join Date: Apr 2011
|
RF7 Upgrade for $49 comes with the new dongle?
|
02-01-2014, 09:10 PM | #51 (permalink) |
Registered Users
Join Date: May 2013
|
Not sure. Most likely not.
__________________
Bubba Goblin 700 Jeti DS-16 |
02-02-2014, 08:35 AM | #52 (permalink) |
Registered Users
Join Date: Apr 2013
|
On the Tower site it says Interlink not included !
|
02-02-2014, 09:17 AM | #53 (permalink) |
Registered Users
|
Re: USB wireless to RealFlight
Upgrade does not have a new dongle. The full version no tx does.
I just got my upgrade last week. No dongle. sent from my Verizon Samsung Galaxy Note 2
__________________
Synergy Factory Specialist / Rail Blades / Team Scorpion |
12-16-2015, 12:37 AM | #54 (permalink) |
Registered Users
|
Wiring up my InterLink tonight with these screenshots. I'll let you know how it goes.
__________________
Protos Max 700, Logo 550SX, Goblin 570 MSH USA Flight Team, MSH Brain, Jeti Model, Cyclone |
12-16-2015, 09:47 AM | #55 (permalink) |
Registered Users
Join Date: Dec 2006
|
My real flight 7.5 has a calibration mode that lets you move sticks and find centers. That may fix bubba's roll problem. It's under the same menu that lets you select another receiver to work with real flight. At least you can watch inputs and see what they do. Dan
__________________
No-Team; Non-Rep, no-skill. Free advice worth every penny. |
Thread Tools | |
Display Modes | |
|
|