VBar governor shutting down midflight

[olander08]

I've been flying with the VBar gov for a few months now, but starting yesterday, I've been experiencing some issues where the governor shuts off mid-flight.

Reviewing the VBar log, this is what happens when it shuts off (excerpt from the attatched .pdf):

2:43 Raised Vibration Level
2:52 Governor Sensor no Signal
2:53 Raised Vibration Level
2:53 Governor Sensor no Signal
2:54 Governor Sensor no Signal
2:55 Governor Sensor no Signal
2:58 Governor Mode Stop
3:02 High Vibration Level

I can hover a full pack, but when I start flying normally (quite hard), the gov shuts down mid-flight and I can't start it up without resetting the VBar (shutting on and off). If I try to start it again, I can at times hear a chirping sound when I disengage TH (unknown origin).

I'm running the commander 130hv v5 (or 6?) with the scorpion sensor cable, which should be good (no apparent glitching).

What's going on here?

[Mentalic]

Well the log says no sensor signal, that will shutdown the gov. Why it has no signal is the question, could be be a cut wire a rubbing on carbon, or a poor connection. I'd suggest you inspect your sensor wiring closely.