Jive Pro Problem with Progdisc

[raptor50luvver]

I have just got a Jive Pro 120 and did mode 1 and mode 4 and it arms Ok but motor ran backwards and i wanted to change BEC voltage so i did this with my Progdisc.

Afterwards the ESC wont arm at all,i did Mode 1 and 4 again and all working but after using Progdisc ESC again wont arm.

For now i reset again and swapped wires to get motor running right way and left BEC at default voltage.

Anyone else had this by any chance,i already have a Pro 80 and 120 purchased earlier and these all work OK after Progdisc setting.

[Wh1teAfr1can]

Originally Posted by raptor50luvver

I have just got a Jive Pro 120 and did mode 1 and mode 4 and it arms Ok but motor ran backwards and i wanted to change BEC voltage so i did this with my Progdisc.

Afterwards the ESC wont arm at all,i did Mode 1 and 4 again and all working but after using Progdisc ESC again wont arm.

For now i reset again and swapped wires to get motor running right way and left BEC at default voltage.

Anyone else had this by any chance,i already have a Pro 80 and 120 purchased earlier and these all work OK after Progdisc setting.

have you updated your progdisc to the newest firmware? v1.10? if not that will cause invalid programming and not allow the esc to arm.

progdisc version 1.10 is required for kosmik v 4.6 or later and jivepro v 1.6 or later.

[Ace Dude]

You can download the PROGDISC firmware here:

http://www.kontronik.com/index.php?o...id=193&lang=en

[raptor50luvver]

Ah OK i was not aware there was a new update for the disc.

I will try this and then update here.

Many thanks.