Post your GAUI NX4 Setups

[joallen001]

For those using a push glo or similar where are you grounding?

[caralmar]

Originally Posted by joallen001

For those using a push glo or similar where are you grounding?

I grounded mine to a mounting bolt... See pic.

[joallen001]

Thanks, that is where I was leaning also. Wanted to use the backplate but the screws there are recessed.

[joallen001]

Looks like I may have to buy some hardware to mount the align sensor for the governor. Did you use locknuts behind the frames to hold yours on?

[Si_B]

I just used the little plastic pate which comes with the govenor sensor. Couple of spacers and some longer screws....job done.

[caralmar]

Originally Posted by joallen001

Looks like I may have to buy some hardware to mount the align sensor for the governor. Did you use locknuts behind the frames to hold yours on?

No, two regular small nuts with loctite. Two spacers and washers to secure it all. The spacers are the brass inserts for an old tail pitch slider I had in my junk box.

[backburner1955]

Gaui NX4
Gaui .37 Nitro Engine
Gaui Pipe
Edge 423mm FBL mains
Edge 72mm tails
Skookum SK540 w/ 2 DSMX Satellites
3x Align DS515m Cyclic
1x DS525m on tail
1x DS525m on Throttle
Model Avionics ThrottleMax with RevGlo
Hyperion 2S 1450mah LiFe RX Pack
Scorpion Backup Guard
Rotor Rage 30%

[dodgeboy]

bryan, you get it in the air yet ? throttle jockey all set up ?

[backburner1955]

Not even built yet, too busy bidding on work for this summer...