Jeti ds-16 ikon and cc talon90

[mrloseth]

Anybody have this combo?
Need tips programing the jeti to heli, this is my first heli on the jeti, and there is so many things to do [emoji16]



Marius løseth

[Thunder Fighter]

I have one of my helis using Jeti with and Ikon and CC75 lite ICE, it works very well and should be the same setup as the Talon.

What do you need to know?

//Dennis.

Sent from my Nexus 5 using Tapatalk

[mrloseth]

I have a small problem with the tail, because i have to use trim to get the tail to stand still, and i have sett the gyro sens on the jeti to 38% and the ikon says green and 45% what do i need to do? Is it true that Fbl units i dont use trim on the radio?
I have been out in the heli game for some time. Dont remember all [emoji23]


Marius løseth

[Thunder Fighter]

For sure do not use any trim. Do check the center position on the TX page of the ikon software. It is unusual to see drift with modern fbl controllers but maybe your gain is a too low. I would check that your gyro set point on the TX increases the gain when you change it and start increasing it by 5 points at a time to see if the drift goes away.

//Dennis.

My mobile device and I don't always agree on auto correct choices.

[mrloseth]

Ok :-) il try tomorrow and see if it get better. I must fix the gov also, the ikom does not see thee sensor.


Marius løseth