N7 Help!

[skinart76]

Hey guys, I have run into a snag and need your help please. I had assembled a N7, but ran into an issue where the tail fin drags on the ground when stood upright. Are any of you running into this issue? Or did I assemble something wrong? Any help will be appreciated. Thanks!

--Stan

[Rodney Kirstine]

Both of mine touch the ground.

[skinart76]

Ahh, I see. Thanks for the response RodneyK. I was just worried because it looks like it can sustain quite some damage if, say, you don't land perfectly square on the skids. Have you run into any issues?

[Rodney Kirstine]

Only when I hit the tail hard enough to snap the tail boom in half...

Under regular use, though, it's been just fine.

[skinart76]

Haha, perfect. Thanks!

[Rodney Kirstine]

If you did want to get some clearance for the tail fin you can add some tail blade spacers, or something similar, between the rear landing gear strut and the frame.

[skinart76]

Thanks dude! I was thinking about adding spacers or washers, but, just wanted to be sure I didn't miss something or make a mistake first.

[skinart76]

Also, do any of you guys know what is the measurement of the clutch liner? It's hard to get parts here, so I am trying to figure out if there is an alternative to the stock. Thank you in advance.