START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Align 3G FBL System Align 3G FBL Flybarless System Software and Hardware Support |
|
LinkBack | Thread Tools | Display Modes |
02-11-2010, 07:57 AM | #61 (permalink) | ||
Registered Users
Join Date: Dec 2006
|
Quote:
Quote:
(might be a electronic or software defect as well) |
||
Sponsored Links | |||
Advertisement |
|
02-11-2010, 08:54 PM | #62 (permalink) |
Registered Users
Thread Starter
Join Date: Jan 2009
|
that made sense. thanks. After replacing the cc 10A bec with the BEC Pro (both out-puts into Rx), the heli seem ok. i only flew it twice today cuz it was getting dark. i didn't open up the connectors to check the crimp job on the sensor wire but i did use shoe goo to keep them in place with the 3G controller and gyro. i did get a random tail kick which i read on Align Q&A tips that it's normal for this behavior???
|
02-14-2010, 09:09 AM | #63 (permalink) |
Registered Users
|
I'm watching this thread carefully, as I now have the 3G FBL.
My thoughts: If possible brown-outs are screwing the 3G controller, I'm thinking it should be possible to separate the power to servo's from the controller and have a Ultra clean Linear reg to power the controller, as it's only about 100mA. The servo's would then be run on there own power supply, any glitch on the servo's should not then interfere with the 3G system. What ya reckon? Steve |
Thread Tools | |
Display Modes | |
|
|