CX2 Binding without Bind Plug

[Guitarist93]

Hey everyone,
I want to use my LP5DSM TX for my Blade mSR, but in doing so, I would be unbinding the TX from my Blade CX2, and I don't have a bind plug for the CX2, nor do I want to play $4 for one.
Is there a way to bind the TX to the CX2 without the bind plug?
Can I just connect a wire between the two poles where the bind plug connects?

Thank you!

[Xrayted]

Yes, its just a bridge on the batt port terminals, and you can make it yourself

[Guitarist93]

Originally Posted by Xrayted

Yes, its just a bridge on the batt port terminals, and you can make it yourself

Awesome. Thank you.

[TheBum]

Originally Posted by Xrayted

Yes, its just a bridge on the batt port terminals, and you can make it yourself

Yep, you just bridge the two outside pins (signal and ground).

[whirlydude]

Originally Posted by Guitarist93

Hey everyone,
I want to use my LP5DSM TX for my Blade mSR, but in doing so, I would be unbinding the TX from my Blade CX2, and I don't have a bind plug for the CX2, nor do I want to play $4 for one.
Is there a way to bind the TX to the CX2 without the bind plug?
Can I just connect a wire between the two poles where the bind plug connects?

Thank you!

You won't unbind the LP5DSM from the CX2 just for using the tx on a different model. I have the LP5DSM bound to 4 different models. The only way it would unbind from the CX2 is if the CX2 rx would be bound to a different tx, then one would have to rebind when using the LP5DSM.