When I give left cyclic the motor slows to a stop??

[Porsche911]

Bench testing new X5 on the bench without tail or main blades.
CC Pro programmed for 6volts
2 JR Servo Y adapters for 2 power inputs. One on tail servo and one on cyclic servo
Stock Gaui ESC
4000 6s pack EC5 connectors
Hobbywing RPM sensor
Blue mini VBAR 5.3 pro
8FG Super Transmitter

The electric governor programming went well thanks to MrMel videos.

Now on the bench if I give and hold full left cyclic the motor slows down to a stop.
Does not do this with the other cyclic directions or tail rotor moved left or right.

The 8fg has the live graph for servo movements. Channel 1 moves from 0 to -100 when I push cyclic control stick to full left and +100 when I move the stick full right. The other channels don't show any activity when move the cyclic stick up, down, left or right.

[Porsche911]

Went through the Vbar Governor software setup section again. Problem fixed.
Thanks

[Iceberg86300]

Glad your problem is fixed, but I noticed your Q was in a few different forums, mods don't like that very much. Just a friendly reminder from someone with experience :beer:

Regards,

Steve

Sent from Tapatalk using my Inspire 4g through ATT (meaning it's a wonder you can see this!)