Register Now

Windbreaker · 08-22-2011, 11:11 PM

The heat shrink doesn't provide much protection for the EagleEyes circuit board, and it doesn't allow a secure way to mount it near the receivers which would be on a stand.

So I made one with Plexiglass.

There are holes for all the audio and video jacks, as well as holes and slots to provide access to the two control buttons, adjustment screws and I/O connectors.

The circuit board is supported from below. One of the SMD's are very close to the edge of the circuit board, so the strip of Plexiglass holding up that part of the board had to be carved away.

It's held closed with a couple of small servo screws. Because the case is totally transparent the labels and LEDs are all readily visible. The only difference now is that it's better protected and easy to mount using VHB adhesive.

I'm only using this as a diversity controller for now.

MIRCEA1305 · 01-05-2012, 11:40 PM

Hi Windbreaker,
Awesome case you have there-if it is not too much to ask for can you please share a drawing of it?
Thanks
Regards

landshark501 · 02-06-2012, 04:13 PM

very nifty!

just got mine in..and was thinking how to go about protecting it..
i think you've given me a spark of genious...

i think..

08-22-2011, 11:11 PM	#1 (permalink)
Windbreaker Registered Users My HF Map location Join Date: Sep 2007	Hard case for EagleEyes The heat shrink doesn't provide much protection for the EagleEyes circuit board, and it doesn't allow a secure way to mount it near the receivers which would be on a stand. So I made one with Plexiglass. There are holes for all the audio and video jacks, as well as holes and slots to provide access to the two control buttons, adjustment screws and I/O connectors. The circuit board is supported from below. One of the SMD's are very close to the edge of the circuit board, so the strip of Plexiglass holding up that part of the board had to be carved away. It's held closed with a couple of small servo screws. Because the case is totally transparent the labels and LEDs are all readily visible. The only difference now is that it's better protected and easy to mount using VHB adhesive. I'm only using this as a diversity controller for now. Attached Thumbnails __________________ Custom quad copter, Cobra C-3525/18 motors and ESCs; APC 15x4 thin electric props. OpenPilot ControlCopter board. Futaba 8FG Super 2.4 gHz FAAST system.

02-06-2012, 04:13 PM	#3 (permalink)
landshark501 Registered Users Join Date: Mar 2010	very nifty! just got mine in..and was thinking how to go about protecting it.. i think you've given me a spark of genious... i think.. __________________ what???? i gotta stick to one area of rc?? HA!!!! "COBRA "- "HEADHUNTER" AH-1W HELI BUILD

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-05-2012, 11:40 PM	#2 (permalink)
MIRCEA1305 Registered Users Join Date: Jan 2012	Hi Windbreaker, Awesome case you have there-if it is not too much to ask for can you please share a drawing of it? Thanks Regards

Register Now

Log-in