Ice Lite 50 Hz rate?

[CompleteDestruction]

Does anybody know the Hz rate of a ice lite 50? My FBL gives me the choice of 60 120 200 or 333.

I'm going to assume it's the same for all of castles ESCs

[jhamel]

I assume you are talking about the Spirit FBL unit. It is my understanding that for Jeti, Castle, and HobbyWing ESC's you set the Spirit to 120Hz.

[CompleteDestruction]

Yes

Where do you think I could confirm this? Is this unique to spirit? I just called castle and they say to set it at 60.

[flint723]

I have used a cc ice lite 50a at 1520us 125hz on the Robird. Made no difference vs using it set to Analog which is 50hz. Worked fine both ways.

Does spirit have a setting for 1520us center pulse vs 760us for the throttle channel?

[jhamel]

Originally Posted by CompleteDestruction

Where do you think I could confirm this?

I don't know. There was a discussion about this Throttle Frequency in another thread, but it did not offer a source for verification.

Originally Posted by CompleteDestruction

Is this unique to spirit?

I've never seen it in other FBL units other than Spirit.

Originally Posted by flint723

I have used a cc ice lite 50a at 1520us 125hz on the Robird. Made no difference vs using it set to Analog which is 50hz. Worked fine both ways.

Does spirit have a setting for 1520us center pulse vs 760us for the throttle channel?

I believe you are referring to servo center pulse and frequency; 1520us (cyclic), 760us (rudder).

The OP is referring to the Throttle Frequency of the ESC in this thread.

[CompleteDestruction]

No problem. Thank you so much for the help I will give it a try and report back after work

[CompleteDestruction]

Ok, so at 120hz I see that it reacts to the throttle a little better.. but it still won't go full throttle (solid light). I tried all other setting (Hz) and it's still not working right..

I have taken the travel adjust all the way up in both the tx and the spirit.

I'm thinking the esc is just not ment to work with the spirit.

I can't think of any other settings to change
I think tomorrow I may de-solder my esc, bec, and sensor and solder it all up on an Align esc I have laying around..