Rudder gain

[glennwil]

I am flying CGY 750 with a Futaba 10C and have my rudder gain in transmitter set at about 50%AVC and I have been experiencing some oscillation or slight tail wag,so I was looking in the expert menu at the gain and it's allowable setting is 50%-120%and default is 100%.Does the gain I have set in the transmitter (50%) and the default gain in the expert menu total to give 150% or what? From what I have read I need to reduce the gain until the wag goes away correct?

[steve_b]

Here's the entry from the manual for the setting you've found on the CGY menus.

I'd suggest you just reduce the gain in the transmitter and leave the one in the CGY alone as this parameter is to adjust the gain value in the CGY to the same as the Tx

[glennwil]

Thanks,I got to reading more and that word "base" gain was standing out so I replaced the gain to default.I'll reduce the gain in the transmitter .

[jjoos99]

I am also having alittle bit of wobble now and then but not too bad. The issue that I am seeing is when I stop from a piro the tail will bounce back and forth a time or two before it locks in. Not sure what to adjust for this issue. this is my first flybarless and only have 3 hover flights on it. It is a gasser if that matters.
thanks
Jeff

[dkpodder]

Originally Posted by jjoos99

I am also having alittle bit of wobble now and then but not too bad. The issue that I am seeing is when I stop from a piro the tail will bounce back and forth a time or two before it locks in. Not sure what to adjust for this issue. this is my first flybarless and only have 3 hover flights on it. It is a gasser if that matters.
thanks
Jeff

Try changing the Rudder Basic -» Flt. Mode from 3D to Sports.