START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
FMA/Revolectrix Product Support FMA/Revolectrix Factory Product Support |
|
LinkBack | Thread Tools | Display Modes |
07-10-2011, 01:20 PM | #1 (permalink) |
Registered Users
Join Date: Feb 2009
|
CP Gain Question
I'm very happy with the CP2, but have a question. The helicopter resist forward movement, and requires a fair amount of stick to get things moving. Let off the elevator, and it wants to stop.
I understand this is what it's meant to do, but how do I decrease that effect a little bit? Aileron I am happy with, but elevator needs a lot of stick to get going. Playing around, I put 10% negative expo (less stick, more travel) in the tx and it felt better. Is it stick priority that I increase, or is it pitch gain that I decrease? Thanks!
__________________
When too much is just not enough... |
Sponsored Links | |||
Advertisement |
|
07-10-2011, 04:58 PM | #2 (permalink) |
Registered Users
|
Increasing Stick Priority will improve your issue try 125% and if you feel you need more add accordingly
__________________
MSR x1 / mCPX x2 / 450 x4 / Chaos600 test bed / Chaos600 Air-Wolf / American WereWolf 800 / KFrame800/900/1000 / Assorted Fixed Wing JR9303 / JR9503 / Futaba10CHP |
07-11-2011, 09:40 AM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Feb 2009
|
Thanks for the feedback. It's been a while since I did any changes, and I couldn't recall which was the correct way. It's set to 110 now, so I'll bump it up.
__________________
When too much is just not enough... Last edited by Woody_99; 07-11-2011 at 10:56 AM.. |
Thread Tools | |
Display Modes | |
|
|