programming the MSH YGE for the Mini...

[cpmboy]

Im using a programming card II. All stock on my mini p. What are the settiing suitable for the mini p?...thank you

[Chris Nifty]

Actually default settings are fine except you might want to increase the startup speed to "heli middle". I set low battery cut off to "slow down" @ 3.1 volts. (nb I never let my lipos get that low though). Don't forget to calibrate your throttle endpoints.
If you do a search you'll find a good video in two parts on YGE setup with the Program card 2.

[cpmboy]

Originally Posted by Chris Nifty

Actually default settings are fine except you might want to increase the startup speed to "heli middle". I set low battery cut off to "slow down" @ 3.1 volts. (nb I never let my lipos get that low though). Don't forget to calibrate your throttle endpoints.
If you do a search you'll find a good video in two parts on YGE setup with the Program card 2.

Found it...thanks Chris...

[MiataJohn]

Do you have a like to the two part video? I don't want to screw anything up.

[cpmboy]

oww..one more thing..Im using the beastx and S-Bus. So, from the programming card rx port, do I connect it to the rx (which channel?) or to the beastX (which channel)?

[cpmboy]

Done!!!....at first my motor did not turn when I go full throttle but suddenly turned when stick at low. Well, change the TT channel from NORM to REV...problem solved.