Need specs for Beast x setup

[Birdmanpa]

i am setting up the Beast x after rebuilding my 300x using the Microheli CF frame. I positioned the Beast X on the top platform. I am now going through the set up steps, for the first time and need some help. I am using the stock DS 76 servos and need the frequencies for the B, C, and D setup stages. I can't find them listed so I am hoping someone in here can help. B is swash plate servo frequency from 50 to 200 Hz? C is Tail servo pulse length, 960 760 or 1520. And D has 50 165 270 333 or 560 as options. I want to make sure these are correct. Any help will be appreciated. BTW, the Microheli kit is very well made, every part fit impeccably. The only bitch I have is the servo's are very difficult to get in and out, or adjust especially, aileron and pitch, which require the receiver and platform to be removed every time you need to access them. Sure looks good though. Thanks in advance for any help.

[Murph_d]

Blade 300x manual (page 12)
http://www.bladehelis.com/ProdInfo/F...-Manual_EN.pdf

[ToddMcF2002]

There is a matrix in the 300 CFX manual at least. From memory its 200 cyclic, 1520/270 tail.

[Birdmanpa]

Thank you that is what I needed

[ahahn]

Originally Posted by Birdmanpa

Thank you that is what I needed

Be sure to do the preflight check as shown in the 300X manual. Putting the AR7200X on top will possibly change some servo directions.

[andycrazy]

You will need to go through the sensor directions, piro optimisation etc as these will change with the Beastx mounted on the top. Its best if you go through the complete set up as I think I had to change some of the servo directions as well when I top mounted my beastx unit.