XF600 530kv G3 settings HELP

[Doomsday12valve]

So here is my setup. Trex 600 PRO DFC, 12 cell, CC Edge 160HV, +13/-13 deg pitch, 10 deg cyclic, Radix mains, 96mm Rails. I can't seem to make any good power with this motor. I've tried a lot of different combos on the ESC settings and was wondering what others are running for their gain. I get tail chatter above 14 gov gain. My Scorpion motor I took out was more of a powerhouse than this motor. I was running a hkiii 4035 560kv. I don't want to give up on this motor so any help would be very appreciated.

[DiceK]

Email KDE support and they can give you a special version of castle firmware that gov's better with the KDE motor.

Also I've found that sometimes the "lack of power" on KDE motors is that I've just been using too weak of a battery pack.

[Doomsday12valve]

OK. I'm pretty sure its just an older version of the CC firmware. I've ran two different brands of packs and it flew the same so I'm gonna say its not bad packs. 70c ThunderPower packs should be fine.

[jhamel]

Originally Posted by DiceK

Email KDE support and they can give you a special version of castle firmware that gov's better with the KDE motor.

One can now access the Castle special KDE firmware version on the KDE Website. No need to email Patrick for this anymore.

[Doomsday12valve]

OK THANKS. I'M GONNA DO THAT NOW AND IF I GET A BREAK IN THE WEATHER I'LL GO TRY IT OUT. I'M STILL INTERESTED IN SETTINGS IF ANYONE WOULD LIKE TO CHIME IN AND GIVE THEIR TWO CENTS ON THE ISSUE.