START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Thunder Tiger 60/70/90 Raptor 60/70/90 Helicopters |
|
LinkBack | Thread Tools | Display Modes |
07-12-2010, 03:20 PM | #1 (permalink) |
Registered Users
Join Date: May 2008
|
main shaft thickness
Hi all
What thickness is the raptor 90 se main shaft ?? I want to buy a leveling tool that will fit the shaft ? Any suggestions ?? regards |
Sponsored Links | |||
Advertisement |
|
07-12-2010, 03:25 PM | #2 (permalink) |
Registered Users
|
A swash leveling tool will probably be hard to find on your Raptor 90 because the main shaft diameter is 11mm. The swash on a Raptor 90 is easy enough to level without a tool.
Bob
__________________
Samuel Adams field rep Buffalo Wings field rep Success is the ability to go from one failure to another with no loss of enthusiasm. Churchill |
07-20-2010, 09:59 PM | #3 (permalink) |
Registered Users
Join Date: Feb 2007
|
I was looking for the same thing and never did find one. But really didn't need one after all. I adjusted the links as per the manual and that was it. Just kind of eyeballed it and it was basically perfect.
__________________
X-cell Fury 90: 601/9251, 8231's Cyc; DS650; OS 91MP-6; Jr Vibe 90; OS 91RJX Pipe; Jr 8231 cyclic, 770 3D/G8900, Prfct Reg. CCPM; T-Rex 600 NP: 6965HB, 425MG Throttle GY 520/9254; OS50 Hyper,MP-5, Prfct Reg; 600E Bstx, nue1910 |
07-21-2010, 02:20 AM | #4 (permalink) |
Registered Users
Join Date: Mar 2010
|
Them raptors are easy to set up........an eyeball look here, a tweek there, and usually within real close to neutral lift off...... I'm sold.....
__________________
Raptor 90SE - OS91SX-H - GY611 - 9CHP Raptor 90 3D - YS91SR-GY611-CY atg V3 Memberships: NRA (life); AMA 840156; Tripoli Rocket Association 11843 L3 .........It rubs the lotion on it's skin or else it gets the hose again......... |
07-22-2010, 07:32 PM | #5 (permalink) |
Registered Users
Join Date: Feb 2007
|
don't know if this will work or not.
http://cgi.ebay.com/Swashplate-Level...item3a5d2045ea if it's too large a hole then maybe get some aluminum tubing and make a bushing
__________________
X-cell Fury 90: 601/9251, 8231's Cyc; DS650; OS 91MP-6; Jr Vibe 90; OS 91RJX Pipe; Jr 8231 cyclic, 770 3D/G8900, Prfct Reg. CCPM; T-Rex 600 NP: 6965HB, 425MG Throttle GY 520/9254; OS50 Hyper,MP-5, Prfct Reg; 600E Bstx, nue1910 |
Thread Tools | |
Display Modes | |
|
|