how to wire for zenoah cdi and vBar govenor

[driccard]

Hi all, I am brand new to gassers and I got an HWC/Zenoah with CDI and a vBar Silverline. My question is how do I cable this up, what plugs into what? I really don't want to screw anything up... I appreciate any advise and pictures would be great.

Thanks
driccard

[madog]

You need to use a "Y" cable with 2 male ends. You will have to make this yourself. Just switch one of the female ends with a male. I pull the red wire out of the end that goes in to the Vbar sensor port.

Plug the rpm sensor and CDI in to the Y harness. Now plug the remaining end into the sensor port.

With the Vbar upgrade to pro you can utilize the governor.

[Dennis P]

I am not sure if you are using a 20EI or converted G23 style or HWC but a stator gator is made for the 20EI which uses the same ignition setup as the others.V Bar lists the stator gator as a usable sensor for the Governor so I would check into a Stator Gator possibly?