Programming Needed

[Rmv221]

Does anyone have a good program that I can put into my mSR? I want to match it up to my Spektrum DX7s.

[TheDHndrsn]

Originally Posted by Rmv221

Does anyone have a good program that I can put into my mSR? I want to match it up to my Spektrum DX7s.

I am not clear about what you are asking. If asking about getting the DX7 to work with the mSR you must bind the transmitter to the helicopter. That is easy. If wondering about DX7 transmitter settings for the mSR, also simple. If asking about changing the firmware on the mSR circuit board, not sure there is an answer out there.

If all you need to do is bind, it's very easy.

1. With all transmitters off, power up the mSR by connecting a charged battery. The LED on the mSR circuit board will glow briefly, then go out.
2. After a few seconds, the same LED above will begin flashing rapidly. At this point the mSR is ready to bind.
3. Making sure your throttle is down and controls are centered, power up your DX7 in Bind Mode. To place the DX7 in Bind Mode, push the Bind Mode button on the back of the transmitter as you turn it on.
4. Wait for the flashing LED to stop flashing, and you are done. Power down the mSR and shut off the DX7.

Once binded, you really need not do anything else. This is a fixed pitch heli, so not much to play with. You will find a few threads with transmitter settings for the mSR. Most do nothing more than add expo or mix to rudder and throttle controls. For example ...

https://www.helifreak.com/showthread...hlight=setting

Have fun!

Dave