18mz gyro settings don't match monitor

[agrobatic]

I have the settings for gyro(rud) set to 40%, 50%, 60%, controlled by a 3 pos. switch, SB. On the servo monitor it shows up as 48%, 60%, 72%. It's adding an increasing amount to each value. The fine tune is LD knob, but it's set to zero. Even when I turn down the knob, I can't produce the 40%, 50%, 60% exactly. It's more like 40, 51, 62 when I do that.

[Smith T]

Have you tried setting the end points in the linkage menu. Should be able to adjust everything there to match

[agrobatic]

Good answer. By changing the end point from 100% to 84%, I was able to get the 40/50/60.