TREX 600E DFC Wiring

[Josh S]

looking for Wiring imput and how to place electronic also would like some imput on useing a third battery vrs use just two battery to run the heli

[jhamel]

Check my T600Pro album. Using VBar Silverline, BEC Pro, and CC 120HV. Just using the 2 main packs.

[JayDee]

All depends what you're after, wires running outside the frame or inside (very tidy, but hard to access).
I prefer inside on all my helis, as I'm a clean freak. Like my helis looking clean. Adds a lot of time to the build though, but if you don't crash it's only needed once.
Also, beware of allowing your wires across the edges of the carbon frame. Make sure you light sand them down to blunt the corners, otherwise you will eventually sever the light gauge wires.
I used this thread to give me some tips. Pretty well copied Libtekguy, and the end result is good.
Happy building...