START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
MSH Brain FBL Unit MSH Brain Support Forum |
|
LinkBack | Thread Tools | Display Modes |
04-23-2014, 01:46 PM | #1 (permalink) |
Registered Users
Join Date: Nov 2010
Location: Doral, Florida, USA
|
Ikon - > Tail Servo Horn Centering
Hi, Sometimes due to splines of the servo (or the servo horn) the horn is not perfect 90 degress.
If I want perfect 90 degress of the servo horn. Can I modify a little the neutral of the Servo 4 in Common->Servos->Servo 4 Neutral ? Or I must use the sub-trim option in the transmitter to achieve perfect 90 degress Best Regards
__________________
Align 800e PRO DFC // KRAKEN Yellow // RAW Nitro // Align 700N DFC // RAW Yellow // 2x Goblin 420 // RAW 420 // RealFlight 7.5 // neXt // AccuRc // Tribunus - Vbar Control Touch - Vbar Neo |
Sponsored Links | |||
Advertisement |
|
04-23-2014, 03:14 PM | #2 (permalink) |
Registered Users
|
Never use sub-trim in your TX with an ikon to center a servo. You use Subtrim in the TX to calibrate the center and travels on your TX to the iKON.
If you need to center a servo horn either use the advanced menu as you stated, or use the trim options on the swash servo setup tab.
__________________
Synergy Factory Specialist / Rail Blades / Team Scorpion |
04-23-2014, 07:30 PM | #3 (permalink) |
Registered Users
Join Date: May 2013
|
From what I've seen w/ setting up the tail it's more important that the tail bellcrank is at 90 degrees. As long as the servo has a full range of motion in both directions the position of the servo horn isn't that important, as long as the tail itself is centered.
__________________
Low speed, high drag |
Thread Tools | |
Display Modes | |
|
|