Gryphon 75V 20A Hyper HV BEC (GSR-7075LMT) as a Nitro BEC.

[Chris Sexton]

I happen to have one of these and the Pin Flag switch. I am thinking about putting it on my N5c to give me a On/Off switch capacity so I don't have to remove the canopy after every flight. I know I can get 4-6 flights out of one of my packs, would be nice to NOT have to take the canopy off when I am flying back to back.

The question I have it this:

The specs for the BEC say 3-14s input voltage. My RX pack is a 2s 2550mAh lipo. Is this 3-14s a recommended minimum or will the unit not work correctly on a 2s lipo? I guess I can run a 3s 2200 but would rather keep the weight down.

I have HV servos so this is a very expensive switch I know, but I already have it gathering dust from another failed project.

[Chris Sexton]

Never mind. Just made my own switch with 14 gauge wire and two power leads for amp load. Much cheaper than the gryphon.