I'd like to request a favor....

[Rob43]

I intend to cut out a pair of rear canopy breakaways for my 6HVU. I have everything I needed (wasn't much) shipping (opted to order a 7HV boom, and like Gimpy suggested, cut and notch to fit the 6HVU). The breakaways on my machine were very destroyed in my crash a couple of weekends ago.

I believe the rear breakaways are right angular in shape, with (2) 2.5mm holes where they mount to the frames, and a single 3mm hole for the standoffs. I could make them if I simply know the hole spacing. Could someome take the measurements and reply back?

Thanks in advance, guys.

[Tomy.]

[Rob43]

Thanks, Tomy! Perfect!!

[Rob43]

I made the break away mounts tonight. Worked perfectly. Not much that can't be done with a Dremel! Thanks again, Tomy!

[Tomy.]

You welcome. I might need those in the future too :-)

[B.Ewing]

make some more! i always seem to tear them up. i use a piece of carbon from a synergy kit in its place...but it only attaches to one of the frame screws

[Rob43]

Hahahahah! These were not exactly production parts. You can't tell looking at them on the heli that they are hackers, but when I remove them you can. Also, they are thicker carbon, so might break the frames. It would be better for someone who has a machine to cut several. Mine were very crudely made...Dremel cutoff wheel, hand drill, paper template.