ikon flybarless

[orthobird]

ok,
i went back and put all back to PPM and Jeti, now, i connected the align tail servo, and immediately, the IKON rebooted when i gave any tail servo stick input. if i do not touch the tail stick, the cyclic works fine.

ok, i unplugged the ALIGN servo, and connected the Futaba HV servo. i gave it tail input from the stick, and it did it again, the IKOn rebooted.
so then, i went in the Jeti servo set up page, and decreased the min and max servo output from 100% to 5%. now, the problem is gone. i slowly increased it by 5% to see when problem recurs, and it seems to be at around 40%.

i guess it is both the tail servo and the IKON that are bad???