START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Gryphon Electronics Gryphon Electronics Factory Support Forum |
|
LinkBack | Thread Tools | Display Modes |
06-10-2015, 07:54 PM | #1 (permalink) |
Registered Users
Join Date: Jan 2014
|
GSR-7075-LMT aux port?
Is it okay to plug the High Power Flux LED Board GDB-1030 in the aux port on the GSR-7075-LMT? I did it on my G570 and it seemed ok during my first flight with the board plugged in, but during my second flight I had a complete loss of control. It may just be coincidence that I just installed the board and had the failure?? It is a rekit on the G570 and I am just trying to figure out what happened. I sent the logs to Mikado and they think it was a static discharge that shut down the vbar.
__________________
Protos N700, Synergy 516, SAB Qube Fireball, Align T15, UMX Timber, Alpha 250 3D, Graupner MZ-24 Pro, DX8 G2 |
Sponsored Links | |||
Advertisement |
|
06-11-2015, 10:44 AM | #2 (permalink) |
Registered Users
Thread Starter
Join Date: Jan 2014
|
After working with it today and pulling up the combination LED switch board pictures to see there are two connectors on them, I realized you must use the aux for the LED and the other is strictly for the switch.
__________________
Protos N700, Synergy 516, SAB Qube Fireball, Align T15, UMX Timber, Alpha 250 3D, Graupner MZ-24 Pro, DX8 G2 |
Thread Tools | |
Display Modes | |
|
|