Spektrum - binding to multiple memories

[dfruehwald]

Is it possible to bind the SimStream to more than one memory location in a Spektrum TX supporting multiple memories?

I'd like to have the following for Phoenix:
- Memory setup for calibration
- Memory setup with the Heli settings I like
- Memory setup with the Airplane settings I like

[dfruehwald]

According to Horizon you can. Don't know why I thought the RX was bound to one location at a time.

[ModelGuard]

Lol youve answered your own question.
Basically whatever you can do wired remains the same when using SimStream wirelessly

Sent from my GT-I9300 using Tapatalk 2

[dfruehwald]

I still have not had time to try it but I'm hopeful.

When I read the ModelMatch description it implies you can't.

[ModelGuard]

You are confusing two diferent products sold by me.

SimStream enables you to use your transmitter (Futaba, Spektrum or JR dsm2) to fly your simulator wire free (wireless) on the PC or TV. It binds to your transmitter in exactly the same way as a normal receiver and behaves exactly the same as a wired sim connection except its wireless.

ModelGuard is designed primarily for non Spektrum users and warns you if you try to power up a model that is different to the one shown on your transmitter.
ie if you fit a ModelGuard to a T700 and a Goblin. If you have the transmitter set to 'Goblin' it will warn you as soon as you connect the flight battery.

[truckermusic]

OK....so how do I do this?
I already have my sim stream bound to my Dx7s. And it works wonderful....very happy.

However it is set up as a Heli model in my Tx. on Model #1.
I am now taking some Plane flying lessons and would like to have a plane to fly in Pheonix with out haveing to rebind to my Tx.

so in other words if I want to fly my heli on say on Tx model 1 I select that
If I want to work on my plane skills I select say Model #2.

Will I have to rebind each time I select a different model on my Tx...
Or do I just switch models on my Tx and then just pratice in pheonix???

Am I asking this right???

I guess I am asking, Since my Tx is already bound to Sim Stream on Model 1 to fly my Heli in pheonix do I just create a new model in my Tx and select a plane in Pheonix and fly that? Or do I just select a Plane in Pheonix and fly that........If I do it the last way the Plane does not act correctly because my Tx is set up in Heli mode.....I would need a Model In my Tx set up for Aero for Pheonix to act correctly....

How do we do this???