Pre build

[warped82]

I have the latest version 3 release of the warp 360 so it has the aluminum side plates and the like. I would also suggest that they are getting a bit better with their tolerances.

Upon inspection of the axial play,its no more than 500 micron which I would have said is quite a good fit.

I grabbed the verniers out measured from end to end of the blade holders, divided by two and then measured out the distance and saw where it landed, and it was as good as i could see right in the middle of the tail shaft. Good enough for me.

Once I put the pitch arm on, it was really stiff, more than I would like to have, so i pulled it out, rheamed out the ball link and added some synthetic PTFE lithium grease and slowly nipped up the cap head until it went stiff and then backed it out slightly till it moved freely again.

Now it moves with a slight amount of resistance but really smooth.