Help setting up Turnigy 9X TX with FM for off/on/position hold

[Ohio_Danimal]

Does anyone here have experience with setting up the Turnigy 9X TX switch to be able to turn my FM from off...to one...to position hold?

I have tried and failed. Apparently I need my hand held and a walkthgrough of the procedure (pretend I am a very small child lol)

Thanks in advance!

[pril250]

You don't need to do anything to FM programming wise. All you need is to plug the Blue wire into a spare channel in the RX which corresponds to a three way switch or slider on the tx and program the end points for -70, 0, +70 for example where the neg value will be balance mod, zer will be off and positive will be position mod. Hope this helps.

[Ohio_Danimal]

Thanks for the info.
Does anyone here know the specifics of assigning the three way switch (marked AUX 2) on the Turnigy 9X TX?

[Ohio_Danimal]

Sorry...the three-way switch on the 9X tx is marked "AUX 3", not AUX2

so looking for the way to assign the FM function to that switch

[alchemy66]

I don't think you can program the 3 way for flymentor functions with the standard firmware but I know you can assign one of the rotary pots to do the job.. Is this the standard 9x firmware or the er9x firmware on your transmitter? I no longer have my 9x but I think it's in the AUX settting, assign one of the pots to the channel that controls the flymentor gain. It's not a great solution but it works.

[Ohio_Danimal]

Originally Posted by alchemy66

I don't think you can program the 3 way for flymentor functions with the standard firmware but I know you can assign one of the rotary pots to do the job.. Is this the standard 9x firmware or the er9x firmware on your transmitter? I no longer have my 9x but I think it's in the AUX settting, assign one of the pots to the channel that controls the flymentor gain. It's not a great solution but it works.

Thanks...I think for now I am leaving the blue and green disconnected (Flymentor always on) until I get it sorted out.
I'll adjust gyro setting and stabilization setting through my Flymentor Program card